1. Vacuum Control - Set number to desired vacuum time. 0
to10
2. Gas Flush Control - Set number to desired gas amount.
Set to “0” if no gas flush is needed.
3. Sealing Control - Set number for desired seal time. Do
not exceed “3” on first test.
4. Power Indicating Light
5. Cooling Control - This is a dwell or delay before the vent
function. Minimum setting is “3”
6. Emergency Stop (When you press this button, the cycle
will be terminated and will advance to the vent function.)
to10
2. Gas Flush Control - Set number to desired gas amount.
Set to “0” if no gas flush is needed.
3. Sealing Control - Set number for desired seal time. Do
not exceed “3” on first test.
4. Power Indicating Light
5. Cooling Control - This is a dwell or delay before the vent
function. Minimum setting is “3”
6. Emergency Stop (When you press this button, the cycle
will be terminated and will advance to the vent function.)
| PA-01 Control Panel User Instructions The desired number set on the panel is a time based setting. Each function should be tested for proper results. Note - the numbers do not equate to seconds. The numbers are a “0 – 10” reference. |
Sealers Unlimited‘Since 1979’ Hand Impulse Sealers-Foot Sealers-Vacuum Sealers Ph (760) 522-8389 Fax (760)-888-2000 Chamber vacuum sealers, vacuum sealer bags |
| Econovac-420 NOW COME WITH ANALOG CONTROL PANEL New easier to use than LDC Display Type. |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |